BMW K 1100 RS Repair Manual Page 33

  • Download
  • Add to my manuals
  • Print
  • Page
    / 364
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 32
00.25
Checking idle speed, synchronising
and CO value and adjusting if nec-
essary
Inspections I, II, III, IV
L Note:
The basic settings (ignition, valve clearance) must
be correct.
Adjusting idle speed
Remove knee pad.
Remove left side section of fairing.
Remove caps (1) at the vacuum connections.
Connect hoses of the synchrotester,
BMW No. 13 0 800, in the specified order (note
markings 1 - 4 on tester housing).
Connect tester to motocycle’s power socket with
the corresponding adapter lead.
Start engine and allow to run for app.10 minutes
if not already warm.
e Caution:
Max. idling time at a standstill = 20 minutes.
Run the engine at idle speed.
Select “bar diagram” display with maximum
resolution.
L Note:
If the differences between the individual bars (col-
umns) is very large (more than 2 - 5 mm) switch over
to curve display and compare the individual cylin-
ders with each other; perform defect diagnosis if
necessary.
Rectify defects.
e Caution:
The throttle butterfly adjusting screws (2) are sealed
with lacquer and must not be turned.
Adjust synchronisation at idle speed by turning
the air control screws (3) until the bars/curves are
at the same height, then adjust idle speed.
Idle speed........................................... 950 ± 50 rpm
LT000280
3
1
2
Page view 32
1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 363 364

Comments to this Manuals

No comments