BMW K 1100 RS Repair Manual Page 281

  • Download
  • Add to my manuals
  • Print
  • Page
    / 364
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 280
34.23
Dismantling and assembling rear
brake caliper
Dismantling rear brake caliper
Remove keepers (1).
Drive out spring (2) and retaining pin (3).
Take out brake pads.
Seal the bleed screw.
X Tightening torque:
Bleed screw at brake caliper rear................. 11 Nm
Remove sealing rings (4) from left/right cylinder.
e Caution:
Keep fingers away from gap between pistons and
side contact face of brake pads; risk of injury!
If necessary press back with screwdriver carefully.
Hold a cloth over the brake caliper piston.
Carefully press out brake piston (6) with a com-
pressed air gun applied to the connecting bore;
work at low air pressure.
Remove sealing rings (5) from left/right cylinder
hole.
Assembling rear brake caliper
Coat the new sealing rings with brake fluid and
insert them into the left/right brake caliper cylin-
ders.
e Caution:
Do not tilt the brake pistons when installing.
Coat both brake caliper pistons with brake fluid
and install them.
L Note:
The installed position must be correct!
Insert brake pads and secure with retainers.
LT340290
2
1
3
4
6
6
5
5
Page view 280
1 2 ... 276 277 278 279 280 281 282 283 284 285 286 ... 363 364

Comments to this Manuals

No comments