BMW K 1100 RS Repair Manual Page 198

  • Download
  • Add to my manuals
  • Print
  • Page
    / 364
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 197
23.24
Installing transmission cover
Knock out cap (arrow) from the inside using a
drift.
Heat up transmission cover to 100°C.
Parting surface at housing and cover must be
clean and free of grease.
Thinly coat one of the two parting surfaces with
Loctite 574 or with Three-Bond 1209.
With the aid of a drift or screwdriver, press back
locking lever in direction shown by arrow.
Carefully fit cover on the housing.
Screw in screws holding transmission cover and
firmly tighten.
X Tightening torque:
Retaining screws for cover
............................. 9 Nm
Thinly coat end cap (arrow) with
Three-Bond 1209 and knock in with drift by
8 mm (0.31496 in).
Fit idle lock (ball and spring) in idle position.
Screw in screw for idle lock coated with
Loctite 243.
X Tightening torque:
Screw for idle lock
........................................ 13 Nm
LT230420
LT230370
LT230380
Page view 197
1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 363 364

Comments to this Manuals

No comments