BMW SERIE 3 Owner's Manual download pdf (Page 137)

7 Seat heating, right 47

8 Cooling function

9 Automatic recirculated-air control/recircu‐

lated-air mode

10 Air distribution, right

11 Air flow, AUTO intensity

12 Air distribution, left

13 Rear window defroster

14 Interior temperature sensor — always keep

clear

15 Defrosting windows and removing conden‐

sation

Climate control functions in detail

Temperature

Turn the wheel to set the desired

temperature.

The automatic climate control reaches this tem‐

perature as quickly as possible, if necessary by

increasing the cooling or heating output, and

then keeps it constant.

Avoid rapidly switching between different tem‐

perature settings. The automatic climate control

will not have sufficient time to adjust the set

temperature.

AUTO program

Press the button.

Air volume, air distribution, and tem‐

perature are controlled automatically.

Depending on the selected temperature, AUTO

intensity, and outside influences, the air is di‐

rected to the windshield, side windows, upper

body, and into the footwell.

The cooling function, refer to page 137, is

switched on automatically with the AUTO pro‐

gram.

At the same time, a condensation sensor con‐

trols the program so as to prevent window con‐

densation as much as possible.

Intensity of the AUTO program

With the AUTO program switched on, automatic

control of the air volume and air distribution can

be adjusted.

Press the left or right side of the button:

decrease or increase the intensity.

The selected intensity is shown on the display

of the automatic climate control.

Maximum cooling

Press the button.

The system is set to the lowest tem‐

perature, maximum air flow and recirculated-air

mode.

Air flows out of the vents for the upper body re‐

gion. Open them for this purpose.

The air is cooled fastest when the engine is run‐

ning.

The air flow can be adjusted when the program

is active.

Cooling function

The passenger compartment can only be

cooled with the engine running.

Press the button.

The air is cooled and dehumidified and

– depending on the temperature setting –

warmed again.

Depending on the weather, the windshield may

fog up briefly when the engine is started.

The cooling function is switched on automati‐

cally with the AUTO program.

Seite 137

Climate control Controls

137

Online Edition for Part no. 01 40 2 608 633 - 11 09 490

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 324 325

Comments to this Manuals

No comments

BMW SERIE 3 Owner's Manual Page 137

Comments to this Manuals

Related products and manuals for Cars BMW SERIE 3