BMW S 1000 RR - Service Manual download pdf (Page 92)

In the gravel trap

DTC deactivation

On very loose surfaces (for ex-

ample in a gravel trap of a race

track), DTC's attempts to con-

trol propulsive power might re-

duce drive to the extent that the

rear wheel no longer turns. Un-

der these circumstances, BMW

Motorrad recommends temporar-

ily deactivating DTC.

Bear in mind that the rear wheel

will spin on the loose surface and

close the throttle in good time

before you reach a firm surface.

Then reactivate DTC.

Removing and installing

mirrors

Removing mirror

Make sure the ground is level

and firm and place the motor-

cycle on its stand.

On each side, remove nuts 1

and remove the mirrors.

Secure fairing 2 to fairing

bracket 3 on left and right.

If cable ties are used, affix

adhesive tape as protection at

the points where chafing might

occur.

Installing mirrors

Make sure the ground is level

and firm and place the motor-

cycle on its stand.

Remove the fairing-panel

fasteners.

Engage the left and right mir-

rors in mounts 4.

Install the nuts at the rear of

the fairing panel and tighten to

specified torque.

On the race track

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 172 173

No comments

BMW S 1000 RR - Service Manual Page 92