BMW K 1600 GTL Service Manual download pdf (Page 71)

invariably log on all the remote

controls in the set.

Enable logon of the remote

controls as follows:

Switch on ignition.

Press button 2 on the remote

control three times.

One acoustic signal sounds.

Within ten seconds, switch off

the ignition.

Press button 2 on the remote

control three times.

One acoustic signal sounds.

Within ten seconds, switch on

the ignition.

You can now proceed to log on

all the remote controls.

Step through the following pro-

cedure with each remote con-

trol in turn:

Press and hold down buttons 1

and 2 until LED 3 stops flash-

ing.

LED 3 flashes for about ten

seconds.

Release buttons 1 and 2.

LED 3 is illuminated.

Press button 1 or button 2.

One acoustic signal sounds,

LED 3 goes out.

To complete logon:

Switch off ignition.

Three acoustic signals sound.

Logon is also ended when

four remote controls have been

logged on.

if you have logged on the first

remote control and then do not

press a button within approxi-

mately 30 seconds.

Synchronize the remote

controls

If the central locking system

stops responding to the signals

from a remote control, the unit in

question has to be synchronized.

This can happen, for example, if

the buttons on the remote con-

trol were pressed too frequently

while the remote control was out

of range of the anti-theft alarm.

The procedure for synchroniz-

ing the remote controls is as

follows:

4

69

z

Operation

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 180 181

Comments to this Manuals

No comments