BMW HP2 Service Manual download pdf (Page 93)

The start attempt is auto-

matically interrupted if bat-

tery voltage is too low. Recharge

the battery before you start the

engine, or use jump leads and a

donor battery to start.

The engine starts.

Consult the troubleshooting

chart below if the engine re-

fuses to start. ( 154)

Warm-up phase

During the warm-up phase,

LEDs 1 indicate engine

temperature: the colder the

engine the more LEDs show.

At the same time, vertical

segment 2 in the rev. counter

indicates the recommended

maximum engine speed. As

the engine warms up the LEDs

go out and the recommended

maximum engine speed

increases. Once the engine has

reached operating temperature all

the LEDs are off and the engine

can be revved to maximum

speed. The vertical segment

still visible in the rev. counter

indicates the highest permissible

engine speed.

The LEDs will flicker if you rev

the engine past this maximum

permissible speed as indicated

by the rev. counter.

Pre-ride check

The instrument panel runs a test

of the 'General' warning light

when the ignition is switched on:

this is the "Pre-Ride-Check" The

'General' warning light shows first

red and then yellow, so that you

can check that it is in working

order. The test is aborted if you

start the engine before it com-

pletes.

The rev. counter is activated if

the start-logo status is ON.

Phase 1

General warning light shows

red.

Phase 2

General warning light shows

yellow.

If the 'General' warning light does

not show:

Some malfunctions cannot

be indicated if the 'Gener-

al' warning light cannot be dis-

played.

Check that the 'General' warning

6

89

z

Riding

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 186 187

Comments to this Manuals

No comments