Bmw 335i Convertible 2007 User Manual download pdf (Page 113)

Controls

111

Reference At a glanceDriving tipsCommunications NavigationEntertainmentMobility

The corresponding memory button 1 is now

programmed with the signal of the original

hand-held transmitter.

You can operate the device while the ignition is

switched off.

If the device fails to function even after

repeated programming, check whether

the original hand-held transmitter uses an alter-

nating-code system. To do so, either read the

instructions for the original hand-held transmit-

ter or hold down the programmed memory

button 1 of the integrated universal remote

control. If the LED 2 on the integrated universal

remote control flashes rapidly for a short while

and then remains lit for about two seconds, the

original hand-held transmitter uses an alternat-

ing-code system. If it uses an alternating-code

system, program the memory buttons 1 as

described under Alternating-code hand-held

transmitters.<

Alternating-code hand-held

transmitters

To program the integrated universal remote

control, consult the operating instructions for

the device to be set. You will find information

there on the possibilities for synchronization.

When programming hand-held transmitters

that employ an alternating code, please observe

the following supplementary instructions:

Programming will be easier with the aid of

a second person.<

1. Park your vehicle within the range of the

remote-controlled device.

2. Program the integrated universal remote

control as described above in the section

Fixed-code hand-held transmitters.

3. Locate the button on the receiver of the

device to be set, e.g. on the drive unit.

4. Press the button on the receiver of the

device to be set. After step 4, you have

approx. 30 seconds for step 5.

5. Press the programmed memory button 1 of

the integrated universal remote control

three times.

The corresponding memory button 1 is now

programmed with the signal of the original

hand-held transmitter.

If you have any questions, please contact

your BMW center.<

Deleting all stored programs

Press the left and right memory buttons 1 for

approx. 20 seconds until the LED 2 flashes rap-

idly: all stored programs are deleted.

Reassigning individual programs

1. Hold the original hand-held transmitter at a

distance of approx. 4 to 12 in/10 to 30 cm

from the memory buttons 1.

The required distance between the

hand-held transmitter and the mem-

ory buttons 1 depends on the system of the

respective original hand-held transmitter

used.<

2. Press the desired memory button 1 of the

integrated universal remote control.

3. If the LED 2 flashes slowly after approx.

20 seconds, press the transmit key of the

original hand-held transmitter. Release

both buttons as soon as the LED 2 flashes

rapidly. If the LED 2 does not flash rapidly

after approx. 15 seconds, alter the distance

and repeat this step.

Online Edition for Part no. 01 41 0 013 670 - © 02/07 BMW AG

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 271 272

Comments to this Manuals

No comments