8
35
Care and maintenance
Changing the battery
• Remove screw 6 and lift off
the bottom section of
housing 7
• Slide the spent battery 10 out
from underneath retainer 8
and insert the new battery –
making sure the positive
terminal is up
• Place the bottom section of
the housing on projection 11
at the front edge and close
the housing. Make sure that
the two guide pins 9 are
engaged. Tighten the screw.
–If LED 3 lights up after the bat-
tery has been changed, the
remote control unit has to be
synchronised.
• You do this by holding the
remote control unit within the
range of the receiver and
pressing button 1 twice in
succession
–LED 3 starts flashing and
goes out a few seconds later
– The remote control unit is
now ready for use
6
7
8
11
10
9
DWA_5_2_eng.book Seite 35 Dienstag, 1. März 2005 4:59 16
Comments to this Manuals