If you want a harder damping
characteristic, turn adjusting
screw 1 in the direction indic-
ated by the H arrow.
If you want a softer damping
characteristic, turn adjusting
screw 1 in the direction indic-
ated by the S arrow.
Basic setting of rear-sus-
pension damping charac-
teristic
without Electronic Suspen-
sion Adjustment (ESA II)
OE
Basic setting of rear-sus-
pension damping charac-
teristic
Turn the adjusting screw as
far as it will go in the dir-
ection indicated by the H
arrow and then turn it back
one and a half turns in the
direction indicated by the S
arrow. (Full load of fuel, with
rider 85 kg)
Electronic Suspension
Adjustment ESA
with Electronic Suspension Ad-
justment (ESA II)
OE
Settings
Electronic Suspension Adjust-
ment ESA provides a convenient
way of adapting the motorcycle
to the load it carries and the sur-
face over which you intend riding.
In order for this to happen, the
load status must be set and the
desired riding mode selected.
The selected riding mode is
displayed in panel 1 of the
multifunction display and the load
status is displayed in panel 2.
Three load statuses can be
set, with any of the three riding
modes available for each one.
The clock is not shown while the
ESA readout is active.
Further information on the ESA
Electronic Suspension Adjust-
ment system can be found on on
page ( 99).
4
73
z
Operation
Comments to this Manuals