BMW 1200 - BROCHURE 2006 Service Manual Page 128

  • Download
  • Add to my manuals
  • Print
  • Page
    / 180
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 127
Install wheel studs 1 and tight-
en to specified torque.
Rear wheel to wheel car-
rier
Tightening sequence: Tight-
en in diagonally opposite se-
quence
60 Nm
with cross-spoked wheels
OE
Tightening sequence: Tight-
en in diagonally opposite se-
quence
60 Nm
Front-wheel stand
Installing front-wheel
stand
The BMW Motorrad front
wheel stand is not designed
to support motorcycles not fitted
with a centre stand or without
other auxiliary stands. A motor-
cycle resting only on the front
wheel stand and the rear wheel
can topple.
Place the motorcycle on its
centre stand or another auxiliary
stand before lifting the front
wheel with the BMW Motorrad
front-wheel stand.
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Use basic stand with tool num-
ber (0 402 241) in combina-
tion with front-wheel adapter
(0 402 242).
Slacken adjusting screws 1.
Push the two adapters 2 apart
until the front forks fit between
them.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
Align the two adapters 2 so
that the front forks are securely
seated.
Tighten adjusting screws 1.
8
124
z
Maintenance
Page view 127
1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 179 180

Comments to this Manuals

No comments