BMW 328d Owner's Manual Page 206

  • Download
  • Add to my manuals
  • Print
  • Page
    / 255
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 205
7. With the ignition turned on or the engine
running, reel on the compressor.
Switch off the compressor after 10 mi‐
nutes
Do not allow the compressor to run longer than
10 minutes; otherwise, the device will overheat
and may be damaged.◀
Let the compressor run for approx. 3 to 8 mi‐
nutes to fill the tire with sealant and achieve a
tire inflation pressure of approx. 2.5 bar.
While the tire is being filled with sealant, the
tire inflation pressure may sporadically reach
approx. 5 bar. Do not reel off the compressor at
this point.
If a tire inflation pressure of 2 bar is not
reached:
1.
Switch off the compressor.
2. Unscrew the filling hose from the wheel.
3. Drive 33 ft/10 m forward and back to dis‐
tribute the sealant in the tire.
4. Inflate the tire again using the compressor.
If a tire inflation pressure of 2 bar cannot be
reached, contact your service center.
Stowing the Mobility System
1.
Remove the connection hose of the seal‐
ant container from the wheel.
2. Remove the connection hose from the
sealant container.
3. Wrap the empty sealant container and con‐
nection hose in suitable material to avoid
dirtying the cargo area.
4. Stow the Mobility System back in the vehi‐
cle.
Distributing the sealant
Immediately drive approx. 5 miles/10 km to en‐
sure that the sealant is evenly distributed in the
tire.
Do not exceed a speed of 50 mph/80 km/h.
If possible, do not drive at speeds less than
12 mph/20 km/h.
To correct the tire inflation pressure
1.
Stop at a suitable location.
2. Screw the connection hose onto the tire
valve stem.
3. Attach the connection hose directly to the
compressor.
Seite 202
Mobility Wheels and tires
202
Online Edition for Part no. 01 40 2 960 493 - II/15
Page view 205
1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 254 255

Comments to this Manuals

No comments